On this page
Type Alias CreateTileMeshOptions
type CreateTileMeshOptions = {
extendToNorthPole?: boolean;
extendToSouthPole?: boolean;
generateBorders?: boolean;
granularity?: number;
}
extendToNorthPole?: boolean;
extendToSouthPole?: boolean;
generateBorders?: boolean;
granularity?: number;
}
Index
Properties
OptionalextendToNorthPole
extendToNorthPole?: boolean
When true, additional geometry is generated along the north edge of the mesh, connecting it to the pole special vertex position. This geometry replaces the mesh border along this edge, if one is present.
OptionalextendToSouthPole
extendToSouthPole?: boolean
When true, additional geometry is generated along the south edge of the mesh, connecting it to the pole special vertex position. This geometry replaces the mesh border along this edge, if one is present.
OptionalgenerateBorders
generateBorders?: boolean
When true, an additional ring of quads is generated along the border, always extending EXTENT_STENCIL_BORDER units away from the main mesh.
Optionalgranularity
granularity?: number
Specifies how much should the tile mesh be subdivided. A value of 1 leads to a simple quad, a value of 4 will result in a grid of 4x4 quads.
Was this helpful?
Options for generating a tile mesh. Can optionally configure any of the following: